ATA, IP phone, Dect phone, Softswitch, billing world - The SHANG332 used as the application of the Calling Card

The SHANG332 used as the application of the Calling Card

1.      overview

The SHANG332 is because of having the FXO, so it can be used to connect VOIP with the PSTN .The SHANG332 can provide the varieties, such as 8 FXOs,16 FXOs,24 FXOs and 32 FXO...etc. It can be used for the termination service so that the voip calls connects into the PSTN.　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　　

2.      configuration example

When the Calling Card carries completed the Calling Card server,　 they can make use of the FXO gateway at small scaled, with low cost, vivid, for general use etc. broadly develop the access number, but don't need the specialized circuit and PSTN Operators’s support. For example deploy each city with a FXO gateway, each business agent can have the independence FXO gateway and access numbers.

a)       configure the IP address and the Server parameter of Calling Card.

At"quickly install" page, install the IP with the soft commutation address.

The gateway can work under 2 kinds of modes: register and the Peer to Peer. For adopt which kind of method, this depends on the request of the service provider. If use registers mode,it need to set"the Enable Registration"and" Enable Proxy" to yse in the diagram, filling the Registrar and Porxy Address up. If the adoption Peer to Peer method it needs to set"the Enable Registration"and" Enable Proxy" to no.

b)       FXO Gateway VOIP account setting

At"port configuration" page, set the number of the FXO to 123.123 is the SIP account of the Calling Card system. if using registers model, after configuration complete, this page will show the appearance of the port. If it register success, then it show registered.

c)       The system of Calling Card connection setting

The Service Provider of the Calling Card will provide a VOIP access umber, for example 5555. the VOIP Gateway can connect into to the system of Calling Card by this number. You will hear the Welcome message. It will ask you to input account and password.

Need to establish the Auto Mode in the FXO Advanced Confiuration page first. At this option, when calls arrive the FXO Gateway from the PSTN, it will automatically call a FWD Number.

Then click the Display Auto FWD NBR buttone, set the FWD Number.

　

At"Routing direction" page, add a new line, the number 55xx will be routed to VOIP.

　　　

Set the 2th time dialing. For input for the Pin code accurately, please confirm the RFC2833 set to Yes

d)       Peer to Peer Setting

If using Peer to Peer method connects to the Calling Card Server, you need to install the Peer to Peer Calling Route Table. The destination IP is the server address of the Calling Card.